UC Berkeley

Mechanical testing is a valuable tool for assessing intervertebral disc health, but the wide range of testing protocols makes it difficult to compare results from different studies. Normalizing mechanical properties by disc geometry allows for such comparisons, but there is little consistency in the methods by which disc geometry is measured. As such, we hypothesized that methods used to measure disc geometry would impact reported mechanical properties. Disc height and area were measured using computed tomography (CT), digital calipers, and ImageJ to yield three different measurements for disc height and six for disc area. Disc heights measured by digital calipers ex situ were >30% less than disc heights measured in situ by CT, and disc areas measured ex situ using ImageJ were >30% larger than those measured by CT. This significantly affected reported mechanical properties, leading to a 65% reduction in normalized compressive stiffness in the most extreme case. Though we cannot quantitatively correct between methods, results presented in this study suggest that disc geometry measurement methods have a significant impact on normalized mechanical properties and should be accounted for when comparing results.